Laboratory Study on the Polymer Flexible Cement Slurry System

YANG Yanyun


A polymer flexible cement slurry system has been developed because cement stone has poor deformability and can be destroyed easily in complex underground conditions and the subsequent construction of wells. A lot of laboratory experiments has been done to evaluate the properties of this slurry system and the emphasis was put on the properties of cement stone such as compressive strength, flexural strength, corrosion resistance and volume shrinkage. The result of study indicated, this polymer flexible slurry cement system had properties of resisting high temperature, salt endurance, low fluid loss, zero free liquid, the thickening curve emerged right angle with short transition period and anti-gas channeling. The compression strength of the cement stone was high, plasticity was strengthened, permeability was low, it was good to able to bear corrosion.
Key words: Oil well cement; Strength of cement; Flexibility of cement; Resistance to corrosion


Oil well cement; Strength of cement; Flexibility of cement; Resistance to corrosion

Full Text:



[1] Rav, K., & Bosma M. (2011). Safe and economic gas wells through cement design for life of the well. SPE 75700.

[2] Wang, X. L., & Huang Y. C. (1998). Experimental study on dynamic fracture toughness of the concrete rock. Journal of Harbin University of Civil Engineering and Archtecture, 18(5), 8-13.

[3] Chen, D. J., & Liao, G. (2001).Research and application of plastic cement slurry system of deep well in Sichuan. Natural Gas Industry, (3), 36-38.

[4] Cheng, R. C., Bu, Y. H., & Wang, R. H. (2006). Experimental study of toughness-reinforcement and gas block carboncber cement slurry for oil well. Drilling Fluid & Completion Fluid, 23(3), 23-26.

[5] Page, C. L. Short, N. R., & Holden, W. R. (1986). The influence of different cements on chloride induced corrosion of reinforcing steel. Cern. Coner. Res, (16), 147-158.

[6] Wei, Z. S., Ma, H. Z., & Wang, W. B. (2003). GJ-1 cement slurry system for gas reservoir protection and its laboratory evaluation. Drilling Fluid & Completion Fluid, 20(1), 3-7.

[7] Jiang, H. T., Xiao, Z. X., & Lu, S. (2004). Styrene-butadiene latex cement slurry system and its application. Drilling Fluid & Completion Fluid, 21(1), 32-35.

[8] Mao, K. W. (1996). Cause and prevention of casing corrosion in oilwells. Petroleum Drilling Techniques, 21(1), 23-27.

[9] Wang, W. B., Ma, H. Z., & Wei, Z. S. (2004). Laboratory study on impact resistance toughness cement slurry system. Drilling Fluid & Completion Fluid, 21(1), 36-39.

[10] Guo, Z. Q., Zhao, Q., & Yan, P. (2004). Study corrosion resisting of cement slurry. Drilling Fluid & Completion Fluid, 21(6), 37-40.

[11] Yao, X. (1998). Carbon dioxide corrosion in oilwell cement and its prevention measures. Drilling Fluid & Completion Fluid, 15(1), 8-12.



  • There are currently no refbacks.


How to do online submission to another Journal?

If you have already registered in Journal A, then how can you submit another article to Journal B? It takes two steps to make it happen:

1. Register yourself in Journal B as an Author

Find the journal you want to submit to in CATEGORIES, click on “VIEW JOURNAL”, “Online Submissions”, “GO TO LOGIN” and “Edit My Profile”. Check “Author” on the “Edit Profile” page, then “Save”.

2. Submission

Go to “User Home”, and click on “Author” under the name of Journal B. You may start a New Submission by clicking on “CLICK HERE”.

We only use three mailboxes as follows to deal with issues about paper acceptance, payment and submission of electronic versions of our journals to databases:;;

Copyright © 2010 Canadian Research & Development Centre of Sciences and Cultures
Address: 9375 Rue de Roissy Brossard, Québec, J4X 3A1, Canada

Telephone: 1-514-558 6138